If engine is losing oil and the engine is not broken, the motor oil is not doing it job in this "closed" system...

 

Bought it used in February, added the motor treatment as I left the dealer. Have averaged 41mpg since I bought it, 18% improvement over the highway rating Read more

Mitch Jewett 2016 Toyota Camry LE 4 cylinder Thursday, August 9, 2018
2004 Ford Edge

Hello Jim,

I would like to thank you for introducing me to Cerma and to such a quality product.

I am a certified Automotive Service Excellence  Read more

Robert Wilder 2004 Ford Edge Tuesday, June 5, 2012
5.7l VZ Commdore

i bought a ls1 5.7l VZ Commodore Utility at auction driving home the check engine light was on ( engine code low oil pressure) and the oil light came on Read more

Robert K. 5.7l VZ Commodore Tuesday, September 22, 2015
Ford F-150

The amazing Cerma technology! The reason I say amazing is because I worked at Douglas Aircraft in the engineering changes on the DC-9 program way back Read more

Capt. Gary Pylant Ford F-150 Thursday, September 3, 2015
Dipstick

Well its finally complete,.. my VT has been engine treated, 6000 mi. ran in, and turbo treated, 6500 miles ran in. 7500 mi. can around, the "carrier" Motul Read more

Peter K. (aka Gaijii) From Veloster Forum -- CERMA Treatments/Oil/Lubricants: For the good of the order Saturday, December 28, 2013

Hello,
Just want to let you know of the positive results I have had so far: 2300 miles since Cerma was added to crankcase; oil consumption has been cut Read more

Scott A. 2002 Nissan Altima 2.5L Wednesday, June 11, 2014
2006 Mercedes E350 4Matic

6/5/15: I wanted to let you know my 1997 Toyota is running like a top since I started using your products. I am ready to change to Cerma Oil and am looking Read more

Raul Y. 2006 Mercedes E350 4Matic Friday, June 5, 2015
Jeep Grand Cherokee

I purchased a 1996 Jeep Grand Cherokee with 196,000 miles on it. The transmission was beginning to act up after a couple of months driving the vehicle. Read more

Ron R Jeep Grand Cherokee Sunday, April 15, 2012
Toro Push Mower

GREAT product I use CERMA in EVERYTHING from my TORO push mower to both my Chevrolet vehicles with GREATLY improved gas mileage & lawn mower that runs Read more

Anonymous Toro Push Mower Sunday, August 22, 2010
1987 BMW M6

Hi John, I want you to know that the Cerma Transmission Treatment fixed my 25 year old BMW M6 manual tranny, which did not want to go into first gear much Read more

Glenn 1987 BMW M6 and 1989 Chrysler Dynasty Wednesday, February 29, 2012
1990 560 SEC Benz

I never bother writing reviews, however, this product is FANTASTIC!! 560 SEC Benz with 113k miles, about 30k since valves...UNBELIEVABLE!! Cold start Read more

Pdidheon 1990 560 SEC Benz Monday, March 23, 2015

I recently SiC treated a 1100cc motor on a 1984 Honda v65 Sabre VF100S and began with these compression numbers:

Cylinder #1: 120/170 Cylinder Read more

Robert Kientop 1984 Honda v65 Sabre VF100S Wednesday, October 14, 2015
Subaru Imprezza

I am amazed at this product. I put Cerma STM-3 in my 2009 subaru imprezza and went from 33 mpg hwy. to 38 hwy! the engine seems to be so smooth you can't Read more

Brent Richards 2009 Subaru Imprezza and 04 Dodge Hemi Sport Truck Tuesday, September 11, 2012
Mack 350

This stuff is crazy good although I need to replace injection pump on my Mack 350. This product made the truck run the best it has done for a year. Almost Read more

Peter P. Mack 350 Sunday, July 24, 2016
Mercedes Benz '91 560 SEC

CERMA IS THE REAL DEAL!!

I heard about Cerma oil treatment from a friend who had amazing results with a sluggish high-mile Acura minivan. I treated Read more

Patrick M. Mercedes Benz '91 560 SEC Monday, April 6, 2015
2000 Acura TL

Dear John: I had an appointment with Acura concerning an alignment. My 2000 Acura TL has 302,000.00 miles. As you remember from our phone conversation Read more

Gerald S. 2000 Acura TL Tuesday, May 26, 2015
BMW 318i

Hi everyone!

This post is a "give back" I hope to help a few with this one, as so many helped me with replies on my first post. I learned much. At Read more

Mike Wentz '83 BMW 318i Friday, August 7, 2009

Dear Great Cerma Product, I have just used the transmission and engine treatment. So Far So Good. I notice an improvement with the transmission, and the Read more

Robert F. Chevy 1998 Venture LS Monday, December 21, 2015

Did a test session earlier, the initial run since adding the CERMAX 5W40 oil plus the manual transmission treatment.

First thing I noticed when shifting Read more

Veloster Forum Member Hyundai Veloster Thursday, February 6, 2014
2015 Denali 2500

Amazing!! This stuff really works as described and then some. I used it three 2015 GMCs (Denali 1500, Denali 2500, and Yukon XL). Smoothed out the idles Read more

Amazon Customer 2015 Denali 2500 Wednesday, December 23, 2015

I just want to state that other than an amazing product, this company has amazing customer service. The day after ordering my engine treatment I received Read more

Tyler Conklin 2016 Hyundai Veloster Turbo Friday, September 16, 2016
2008 Cadillac Escalade

Dear Cerma, I have attached a photo of the average MPG on the 2008 Cadillac Escalade which was treated at 183,743 Miles. At 183,901 miles, MPG average Read more

Michael H. 2008 Cadillac Escalade Sunday, December 13, 2015
2003 Ford F250

The best. Powered up my 12 year old truck -- it feels like new. I have a Ford F250, 2003 with 200,000.00 miles and in good shape, but after I used this Read more

Giovanni 2003 Ford F250 Thursday, January 21, 2016

Thanks a lot for explaining in detail how Cerma STM-3 works. I'm going to purchase & use one. My vehicle uses 5W-20 engine oil. Its engine has a Multi-Displacement Read more

John Flood Chevy Silverado 6.2 Liter Thursday, August 28, 2014

Just prior to winter in 2012, I used 1/3 an ounce of Cerma engine treatment in my 1999 Craftsman snow blower. In the past it was necessary to have the Read more

Darrell Hails 1999 Craftsman 5 H.P., 22 inch Dual Stage Snow Blower, Model C950-52105-1 Thursday, October 31, 2013
40 FT Meridian Yacht

The boat is going over 28 MPH. Granted clean bottom and props but I don’t believe it ever went over 26ish on this boat. It is a 40 FT Meridian Yacht weighing Read more

Leigh Overland 40 FT Meridian Yacht Wednesday, June 4, 2014
2004 Ford Ranger

When I first went to use this product, I was a bit skeptical, I had an issue with my truck starting. I had tried every chemical to run through the gas Read more

CJ 2004 Ford Ranger, 4.0L, non-turbo, 4 spd automatic 4X4 Sunday, May 3, 2015
  • Cerma STM-3
    Technology and
    Information

    Learn More
  • Cerma Motor Oil
    Technology and
    Information

    Learn More
  • Cerma Blue Ice
    Technology and
    Information

    Learn More